ALTEC LANSING ADA995 DRIVER

See “Additional controls in the speaker controls software. See “Replacing the fuse. The three cables separate from one another several inches from the end, and each of the three cables ends with a different colored plug:. Ask a Question Usually answered in minutes! It allows you independent control of subwoofer volume level for fine-tuning the system. If the center channel speaker fails to sound the test tone, check its cable connection to the subwoofer. Positive Voltage Regulator is blown out:

Uploader: Zolokazahn
Date Added: 7 February 2010
File Size: 39.99 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 39131
Price: Free* [*Free Regsitration Required]

The subwoofer’s test tone will be a lower frequency than that of the center. Open the speaker controls software and make sure the speaker mode is set to 6 Speaker 5.

A spare fuse is included with your system. Posted on Jun 17, Be the first to answer. Table of problems, possible causes, and solutions Symptoms Possible Problem Solution No sound from any speakers Power is not turned on Press Power On button at the rear of the subwoofer. Do not use the center speaker without a stand attached.

It has two stands allowing two different mounting positions. Posted on Jun 25, Be the first to answer.

Answered on May 20, This will enable all six speakers to operate. To prevent electric shock do not use this polarized plug with an extension cord, receptacle or other outlet unless the blades can be fully inserted to prevent blade exposure.

Last Drivers  DIGIDESIGN MBOX 1 DRIVER

If so, signal from sound card is not present. It allows you independent control of subwoofer volume level for fine-tuning the system. The speaker system can remain powered.

The input jacks on the back of the subwoofer are coded with matching colors. Another view of the burnt traces: Wall outlet not functioning Plug another device a,tec the wall outlet same jack to insure it is functioning, or, try plugging the ADA speaker system into a different outlet. Increase the subwoofer volume by adjusting the Subwoofer Level control at the back of the subwoofer.

To prevent electric shock do not use this polarized plug with an extension cord, receptacle or other outled unless the blades can be fully inserted to prevent blade exposure.

Dell Altec Lansing Ada THX Certified Computer Speakers | eBay

The optimum subwoofer level setting varies for different types of music. The center speaker is unstable without either stand installed and lahsing sustain damage from a fall. Make sure the three triple cable plugs are inserted firmly into the correct jacks. Positive Voltage Regulator is blown out: The Subwoofer level control affects the subwoofer level only. If you disconnect the triple cable from the Santa Cruz sound card and the loud hum goes away, then you may need to adjust the volume control using the keyboard as you may be overdriving the volume settings on your speaker system.

Last Drivers  DESKJET D2345 UBUNTU DRIVER

However, these connections drawings show a back view of all the speakers and the subwoofer. A peek at the underside: Should you need to purchase another, the replacement fuse is a Radio Shack part You may altc the fuse only with a fuse of the same type and value as this fuse. This plug is qltec into the left front jack with the brown color marking located at the back of the subwoofer.

Dell Altec Lansing Ada995 5.1 THX Certified Computer Speakers

Do NOT connect the subwoofer to a power source until all speaker system connections have been made. You oansing now position the center speaker on a desktop or other flat surface, but NOT the top of your computer monitor.

If the distance is greater than 5 ft 1. Press Power On button at the rear of the subwoofer. A adx995 bass level control is located on the rear of the subwoofer. Boy that “Heat Sink Transfer Paste” is really messy!!!: