ARGOX X 2000V PPLB DRIVER DOWNLOAD

For pin-out information, please refer to the Technical Reference in this manual. The CD-Rom will bring out the following prompt. Buttons There are three buttons, each with two basic functions. Unless changed via panel or command the parameter is saved even if you restart the printer. FEED Press to show next parameter. Place the printer within cable distance of the host and printer serial or parallel cable. Figure 5 5 26 Notes:

Uploader: Kabei
Date Added: 27 July 2018
File Size: 10.8 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 18011
Price: Free* [*Free Regsitration Required]

Counter-clockwise rotate the screw a half circle and test printing; observe whether the printing quality has been gradually improved or not; and stop the adjustment if the quality is improved.

Ribbon sensor error Replace ribbon sensor Note: Put the media end on the roller. The printer will then feed the labels through the cutter automatically. Turn off the printer. Courier font with different symbol sets.

Seagull Argox X-2000v PPLB Free Driver Download (Official)

Cleaning the Media Compartment Clean the media compartment with a cotton bud that has been moistened with a mild detergent. Figure 1 1 Backing Paper 24 2. Figure 3 3 Dispenser Module Peel Lever 25 4. After media calibration is finished, printer stores settings into its flash. If the ribbon is wrinkled at ribbon supply, rotate clockwise control knob of ribbon supply, to increase ribbon tension at ribbon supply and further improve ribbon wrinkle. Secure the dispenser board onto printer case. Connect the barcode reader to the keyboard interface.

Last Drivers  LYNXTWO B DRIVER

Attach the edge of the ribbon onto the bare core and wind it a bit onto the core. It also badly handles the situation where a printer driver is already in use by a Windows application. Transmission Problems If the host shows “Printer Time out” 1. When the left side of the label exhibits inferior printing quality, as shown in Fig.

Risk of explosion if battery is replaced by an incorrect type. Need to reboot the system. Print a test page to check print quality. Water or spit should be kept away in case of corrosion on heating elements.

Make a form for barcode reader. For the XVL, ignore this step.

Be cautioned that this will reset all printer settings back to defaults; if possible, print the configuration label in advance before reset. The other end of the parallel interface cable connects to the printer connector at the host computer.

Step 4 is automatically repeated.

Argox X Industrial Label Printer.

For labels with gaps, label sensor can be positioned wherever media locates. Argod the test print appears as Figure A, remain the screw at the right of Ribbon Bracket fixed, then loose the screw at the left, and gradually fine-tune upward, until the print quality gets improved.

Last Drivers  MATSHITA UJ870 DRIVER DOWNLOAD

Normally the procedure for loading the media through the cutter is: Push down the peel-off mechanism release lever and lead the media under the peeler module. Inspect the outside of both the box and the printer for 5 possible damage.

Argox X |

Then release the buttons to enter settings. Open the left cover of printer. Now printer is in normal printing mode. During turning the Cam of cutter, release the blade from paper and arhox remove the paper from the cutter.